top of page

WHAT'S IN THE KIT?

BODY

Rudder
Elevator
Aileron
Fuselage
Fuselage Cover

ELECTRONICS

Pixhawk
Flight controller of the fixed wing UAV
Air Speed Sensor
Used in barometric calculations and airspeed reading
GPS
The Global Positioning System is a satellite navigation which uses a radio receiver to gather the signals from satellites and use that information to determine the speed, position, and time
Motor
Buzzer
Also known as the tone alarm, is used to play different sounds which include the Arming buzz and the Lost Copter Alarm
RGB Module
Increases the USB port for easy links from external USB cable and extends the exterior RGB LED display of the Pixhawk
Servos
Connected to the Pixhawk which control the movement of the ailerons, elevator, and rudder.

Source: AliExpress

Radio Transmitter
FrSky 2.4G Taranis X9D Plus
Battery
Tiger Power 14.8V 5400 mAh 4cell 35C LiPo Battery
Safety Switch
It is used to enable or disable the outputs to motors and servos
Electronic Speed Controller
Responsible for spinning the motors at the speed requested by the autopilot. Most ESCs need to be calibrated so that they know the minimum and maximum PWM values that the flight controller will send
Power Module
It is used to power the flight controller and monitors the voltage and current of the battery and triggers a return-to-launch when the voltage becomes low or the total power consumed during the flight approaches the battery’s capacity

Source: AliExpress

Telemetry
RF Design Long Range Telemetry Radio, a support sharing information with a ground station (transmitter) which is a two-way data stream that sends data about the flight to a ground station and sends command to the autopilot

Source: www.hobbyking.com

Radio Receiver
X8R receiver (included with FrSky 2.4G Taranis X9D Plus)

HARDWARE

Servo Rods 
Fuselage Cover Latch Screws
Motor Mount
Carbon Tail
Wing Spacer
Rubber Bands
Carbon Tail Mount
Rudder Joint
bottom of page